Vaperz Cloud Asgard 30mm RDA

The Vaperz Cloud Asgard 30mm RDA is a large rebuildable dripping atomiser, recommended for advanced vapers. Designed for use with a squonk vape device, it is fitted with a bottom-feeding pin allowing e-liquid to travel to the build deck to saturate your cotton. Featuring a postless build deck, you can use either single or dual coil builds.

Features:

• Vaperz Cloud RDA
• Squonk RDA
• Postless build deck
• Single or dual coil builds
• Dual top airflow
• Ultem heat shield

Thanks to the large size and postless design, the Asgard build deck can fit a range of coil types. This means it’s very easy to configure to create large amounts of vapour or offers a more discreet level of loud – supporting mouth to lung or direct to lung vaping.

To allow for greater control over vapour flow and production, the dual adjustable airflow can be opened or closed to different degrees – allowing for a wider or looser inhale, as well increased or decreased vapour production. Inside the top cap is an Ultem shield which concentrates the heat from the coil.

Please note: The pink Asgard 30mm RDA is stamped with the breast cancer awareness symbol, from the sale of each a small proceed will go to charity.

Contains:

• Vaperz Cloud Asgard 30mm RDA
• Beauty Ring
• Spare O-Rings
• Replacement Screws

Important information about Rebuildable Dripping Atomisers:

Rebuildable atomisers are recommended only for experienced users. You should have the knowledge and access to the equipment that is required to set up this atomiser properly.

Before building coils or using an RDA you should have a thorough knowledge of battery safety, Ohm’s Law and vaping in general.

Before fitting a coil onto your rebuildable atomiser ensure it is in a safe condition and registering the correct Ohmage, this testing and checking can be achieved by using a dedicated Ohmmeter. Coils should not be tested on vape devices.